I am trying to test a small sketch on the Bluz, but after flashing and trying to connect to the app or gateway shield the Bluz just gets stuck at the slow flashing blue light. I then reset and reflash (Beta 4 or Beta 5) with the same sketch am I then in the same state. If I use the gateway shield it just gets stuck at the flashing blue light. If I use the iOS gateway app the app just closes when trying to connect. If I use the Android app it starts to connect, starts flashing blue, and then the app just stops trying to connect.
I’m not sure how, but after leaving it off for a few minutes it is fine now. I can flash between sketches without issue now.